1. Find a suitable location for your BubbaRubba.
2. Mark a small pencil dot at 60 inches from the floor on the very corner. This will mark where the top of the BubbaRubba will go. 60 inches covers most average heights. You may want it higher or lower. Adjust the mark if necessary before application to wall.
3. Affix the 10 adhesive pads to your BubbaRubba (See below for detailed instructions). Place one at each corner, close to the edge and place the remaining pads equally between the corner pads.
4. Before exposing the adhesive, make a trial fit to your wall to be sure this is where you want to set the BubbaRubba. REMEMBER ONCE PLACED IT IS NOT EASILY MOVED.
5. Peel the backing off the adhesive pads; place the top of the BubbaRubba on the pencil mark while holding the bottom away from the wall making sure of proper alignment. Push the top all the way in so the plastic indexes the corner and fits against the wall. Slowly move the bottom in until it indexes the corner.
6. Once in place, push the adhesive pads so they firmly adhere your BubbaRubba to the wall. firmly adhere your BubbaRubba to the wall.

Additional  Information and Options:

Spacing the adhesive pads is easily acomplished.

Start by removing the backing off of one pad at a time and placing it on the inside of the back scratcher in the space between the bumps starting at the top corner then do the opposite side, now do the opposite end. Now place a pad in the center of the backscratcher between the pads already installed, do the opposite side. Finally place the remaining pads in between the spaces between the six pads already installed so the ten pads are evenly spaced along both sides of the back scratcher, five on each side evenly spaced down both sides.

The BubbaRubba may be screwed to the surface with small pan head screws. We do not reccommend wood screws as the tend to spread the plastic.

Also apply the back scratcher to corner trim, door jamb or any smooth surface with a 90 degree angled corner. The adhesive adheres best to smooth golssy surfaces. If replacement adhesive is required we reccommend 3M #859 Clear Mounting Squares. This product is available at most stores in the stationary products section. Or contact us for replacement pads..

Below is a view of the adhesive locations shown by the red areas on the back scratcher


   Thank You for visiting our website
Remember this product is Proudly hand made made in the United States of America
Please order one for yourself and another as a gift for a friend.

Disclaimer

Having no control over the end use of this product, nor the user’s ability or judgment to use or handle this product, Jack Mitchell Enterprises, Inc. maker of  BubbaRubba™, Partners LLC nor their distributors accepts any responsibility nor shall be held liable for damage of any type related to the use of this product. No warranty exists, either expressed or implied that  shall exceed replacement of the defective product.